Adjusting Bass And Treble; Listening With Sound Delay - Pioneer Elite VSX-53TX Operating Instructions Manual

Adjusting Bass and Treble

You can adjust the low (bass) and high (treble) frequencies. The TONE button can also be used to bypass the tone
circuitry.
2 3 4

Listening with Sound Delay

Some video displays have a slight delay in presentation of the video. Using sound delay you can slow the
presentation of the sound to match the presentation of the video.
1 Press RECEIVER.
2 Press the TONE button on the remote
control or the front panel to put the
receiver in tone adjust mode.
Pressing the TONE button changes the mode to either on
or off. When the mode is set to on, TONE appears in the
display.
3 Press the BASS/TREBLE button
repeatedly to select BASS or TREBLE.
If TONE: BYPASS appears, press the TONE button to get
TONE: on.
4 Use the +/– buttons to adjust the low
or high frequency levels.
A few seconds after you finish adjusting the tone the
receiver will revert to the sound mode it was in at the
beginning of the process.
Memo:
• The tone control can be adjusted in a range of ±6 dB.
• The tone control cannot be set on in THX CINEMA,
MULTI CH IN modes.
• If you set TONE control on in DIRECT mode the receiver
will switch to STEREO mode.
1 Press RECEIVER.
2 Press the EFFECT/CH SEL button
repeatedly until you see DELAY in the
receiver's display.
3 Use the +/– buttons to add or
subtract the amount of delay.
Memo:
• The amount of delay changes in 0.1 frame steps from
0.0 – 6.0 frame. (The default setting value is 0.0 frame.)
• When in DIRECT or MULTI CH IN modes, sound delay
cannot be used.
Basic Operation
51