Software Update; Software Update Messages; Sound Settings; Using The Virtual Surround/Sound Retriever - Pioneer Elite X-SMC4-K Operating Instructions Manual

Changing the settings

Software Update

Use this procedure to update the unit's software. You can
update the software via a USB storage device.
Updating via a USB storage device is performed by
downloading the update file from a computer, reading this file
onto a USB storage device then inserting the USB storage
device into the USB port on the unit's front panel.
• If an update file is provided on the Pioneer website,
download it onto your computer. When downloading an
update file from the Pioneer website onto your
computer, the file will be in ZIP format. Unzip the ZIP file
before saving it on the USB storage device. If there are
any old downloaded files or downloaded files for other
models on the USB storage device, delete them.
Important
• DO NOT unplug the power cord during updating.
• When updating via a USB storage device, do not
disconnect the USB storage device.
Press FUNCTION / to select USB as the
1
input source.
USB is shown on the main display.
2 Press SET UP.
The Initial Setup screen is displayed on the main display.
3 Select Option Setting
Start, then press ENTER.
Software Update
Start
Cancel
4 To update, select OK.
The updating screen appears and updating starts.
• The power turns off automatically once updating is
completed.
 
Software Update

Software Update messages

Status
Description
messages
No update file was found on the USB storage
File Not Found.
device. Store the file in the USB storage
device's root directory.

Sound settings

Using the Virtual Surround/Sound Retriever

You can add exciting effects to audio sources.
1 Press SOUND to select Virtual Surround or
Sound Retriever.
Use / to select On or Off, then press
2
ENTER.
About Sound Retriever
This function enhances sound data lost during compression
of MP3 and other file types, allowing the user to enjoy sound
quality closer to that of the original signal data.

Adjusting the bass and treble

Use the bass and treble controls to adjust the overall tone.
1 Press SOUND to select Bass or Treble.
Use / to adjust the bass or treble, then
2
press ENTER.
You can adjust low and high sounds on a scale of –5 to +5
(eleven steps).

Resetting the system

Use this procedure to reset all system settings to the factory
default.
Important
• Disconnect all components connected to this unit
before the operation.
1 Press STANDBY/ON.
The unit turns on.
Press and hold  and STANDBY/ON on
2
the top panel for three seconds.
The unit turns off (standby mode).
All the settings will be reset to the factory default next time the
unit is turned on.
12
35
En