Assigning The Digital Inputs - Pioneer Elite VSX-53TX Operating Instructions Manual

Assigning the Digital Inputs

If you did not hook up your digital equipment in accordance with the default settings for the digital inputs (see
pages 17, 19 and 22) you need to complete the procedure below. You have to do this in order to tell the receiver what
digital equipment is hooked up to which terminal so the buttons on the remote correspond to what you have hooked
up.
3-8 2
3
4
5
Memo:
• The possible digital inputs that can be assigned
are: DVD/LD, TV/SAT, VCR1, VCR2, CD, CD-R, MD.
• If you assign a digital input to a certain function (for
example DVD/LD) then any digital inputs previously
assigned to that function will automatically be set
to OFF. This is because one function cannot be
assigned to two different places.
Fine Tuning Your System
1 Turn on the receiver and your TV,
press RECEIVER on the remote con-
trol.
2 Press the SYSTEM SETUP button.
3 Looking at the on-screen display on
your TV, use the  buttons to select
INPUT ASSIGN. Press the ENTER
button.
4 DIGITAL–IN SELECT should be
selected, if not use the  buttons to
select it. Press the ENTER button.
5 Use the  buttons to move through
the different digital inputs and press
the ENTER button.
6 Use the  buttons select the
component that you hooked up to
that digital in. Press the ENTER
button.
If you're not sure which component is connected to which
digital in, look on the back of the receiver and check the
cables you connected.
7 When you're finished use the 
buttons to select EXIT and press
ENTER.
This exits the DIGITAL–IN SELECT mode.
8 Use the  buttons to select EXIT
and press ENTER. Then, use the 
buttons to select EXIT and press
ENTER again.
This exits the SYSTEM SETUP mode and returns to
normal operation.
81