Erasing One Of The Remote Control Button; Settings - Pioneer VSX-916-K Operating Instructions Manual

11 Controlling the rest of your system
• The remote controls should be 2 cm to 5
cm apart.
5 Press the corresponding button on the
other remote control that is sending
(teaching) the signal to this receiver's remote
control.
For example, if you want to learn the playback
control signal, press and hold
seconds. The LCD display will show OK if the
operation has been learned.
If for some reasons the operation hasn't been
learned the LCD will display ERROR briefly and
then display PRES KEY again. If this happens,
keep pressing the (teaching) button as you vary
the distance between the two remotes, until
the LCD display shows OK.
Certain buttons represent operations that
cannot be learned from other remote controls.
The buttons available are shown below:
RECEIVER
INPUT
SELECT
DVD TV DVR
CD-R/TAPE USB
CD FM AM
SLEEP
SB ch
SR+ DIMMER
DIALOG E
D.ACCESS
+10
TOP MENU
TUNE
ST ST
ENTER
SETUP
TUNE
PTY SEARCH
GUIDE
Note
1 • Some commands from other remote controls cannot be learned, but in most cases the remotes just need to be moved closer
together or farther apart.
• If the remote LCD shows ERROR, it may also mean the memory is full. See Programming signals from other remote controls
below to erase a programmed button you're not using to free up more memory.
52
En
2 cm to 5 cm
for a couple of
1
SYSTEM OFF
SOURCE
GUIDE
TV CONTROL
INPUT
TV CH
TV VOL
SELECT
TV CTRL
REC
A
RECEIVER
MUTE
MPX EON REC STOP JUKEBOX
B
C D
ANALOG
ATT
HDD
AUDIO SUBTITLE
MIDNIGHT/
DISP CH
LOUDNESS
STANDARD ADV.SURR STEREO AUTO SURR
MULTI OPE S.RETRIEVER ACOUSTIC EQ SIGNAL SEL
CLASS
DISC
ENTER
SHIFT EFFECT/CH SEL
MENU
T.EDIT
RETURN
RECEIVER
6 To program additional signals for the
current component repeat steps 4 and 5.
To program signals for another component,
exit and repeat steps 1 through 5.
7 Press and hold the RECEIVER button for
two seconds to exit and store the
operation(s).
Erasing one of the remote
control button settings
This erases a control assigned to one of the
buttons and restores it to the factory default.
1 While pressing the RECEIVER button,
press the SETUP button.
The remote LCD display shows SETUP.
2 Use
ENTER .
The LCD on the remote displays the
component.
3 Press the MULTI CONTROL button
corresponding to the button setting to be
erased then press ENTER .
The remote LCD display flashes PRES KEY.
4 Press and hold the button to be erased for
two seconds.
VOL
The LCD display shows OK or NO CODE to
confirm the button has been erased.
5 Repeat step 4 to erase other buttons.
E
DVD
6 Press and hold the RECEIVER button for
CH
two seconds when you're done.
to select ERASE then press