Erasing All Of The Remote Control Presets; Direct Function; Confirming Preset Codes; Multi Operation And System Off - Pioneer VSX-916-K Operating Instructions Manual

Controlling the rest of your system
Erasing all of the remote control
presets
This will erase all preset remote control preset
codes.
1 While pressing the RECEIVER button,
press the SETUP button.
The remote LCD display shows SETUP.
2 Use to select RESET then press
ENTER .
3 Press and hold ENTER for about two
seconds .
The LCD shows OK to confirm the remote
presets have been erased.

Direct function

• Default setting: ON
You can use the direct function feature to
control one component using the remote
control while at the same time, using your
receiver to playback a different component.
This could let you, for example, use the remote
control to set up and listen to a CD on the
receiver and then use the remote control to
rewind a tape in your VCR while you continue
to listen to your CD player.
When direct function is on, any component
you select (using the MULTI CONTROL
buttons) will be selected by both the receiver
and the remote control. When you turn direct
function off, you can operate the remote
control without affecting the receiver.
1 While pressing the RECEIVER button,
press the SETUP button.
The remote LCD display shows SETUP.
Note
1 You can't use direct function with the TV CTRL function.
2 • Before Multi Operation and System Off will work correctly, you must setup the remote to work with your TV and other com-
ponents (see Setting the remote to control other components on page 50 for more on this).
• Some units may take some time to power up, in which case multiple operations may not be possible.
• Power on and off commands only work with components that have a standby mode.
2 Use
ENTER .
3 Press the MULTI CONTROL button for the
component you want to control then press
ENTER .
The LCD on the remote displays the
component you want to control.
4 Use
OFF then press ENTER .
The LCD shows OK to confirm the setting.

Confirming preset codes

Use this feature to check which preset code is
assigned to a MULTI CONTROL button.
1 While pressing the RECEIVER button,
press the SETUP button.
The remote LCD display shows SETUP.
2 Use
ENTER .
3 Press the MULTI CONTROL button of the
component for which you want to check the
preset code then press ENTER .
The brand name and preset code appears in
the display for three seconds.

Multi Operation and System Off

The Multi Operation feature allows you to
program a series of up to 5 commands for the
components in your system. For example, you
could turn on your TV, turn on your DVD player
1
and start playing the loaded DVD using only
two buttons on the remote control.
Similar to multi operations, System Off allows
you to use one button to stop and switch off a
series of components in your system at the
same time.
to select DIRECT F then press
to switch direct function ON or
to select READ ID then press
2
11
53
En