Saving Station Presets; Naming Station Presets; Listening To Station Presets - Pioneer VSX-916-K Operating Instructions Manual

09 Using the tuner

Saving station presets

If you often listen to a particular radio station,
it's convenient to have the receiver store the
frequency for easy recall whenever you want to
listen to that station. This saves the effort of
manually tuning in each time. This unit can
memorize up to 30 stations, stored in three
banks, or classes, (A, B and C) of 10 stations
each. When saving an FM frequency, the MPX
setting (see previous page) is also stored.
1 Tune to a station you want to memorize.
See Listening to the radio on the previous page
for more on this.
2 Press T.EDIT (TUNER EDIT).
The display shows ST. MEMORY, then a
blinking memory class.
3 Press CLASS to select one of the three
classes then press ST
station preset you want.
You can also use the number buttons or the
MULTI JOG dial (front panel) to select a station
preset.
4 Press ENTER .
After pressing ENTER, the preset class and
number stop blinking and the receiver stores
the station.

Naming station presets

For easier identification, you can name your
station presets.
1 Choose the station preset you want to
name.
See Listening to station presets below for how
to do this.
2 Press T.EDIT (TUNER EDIT).
The display shows ST. NAME, then a blinking
cursor at the first character position.
3 Input the name you want.
Choose a name up to four characters long.
46
En
to select the
• Use the MULTI JOG dial (front panel) or the
ST buttons (remote) to select
characters.
• Press ENTER to confirm a character. If no
character is input, a space is input.
• The name is stored when ENTER is pressed
after choosing the fourth character.
Tip
• To erase a station name, simply repeat
steps 1 to 3 and input four spaces instead
of a name.
Once you have named a station preset, you
can press DISP when listening to a station
to switch the display between name and
frequency. It also displays RDS information
(page 47).

Listening to station presets

You will need to have some presets stored to do
this. See Saving station presets above if you
haven't done this already.
1 Press FM, then press CLASS to select the
class in which the station is stored.
Press repeatedly to cycle through classes A, B
and C.
2 Press ST to select the station preset
you want.
• You can also use the number buttons on
the remote control to recall the station
preset.