Connecting Up; Making Cable Connections; Analog Audio Cables; Digital Audio Cables - Pioneer VSX-916-K Operating Instructions Manual

Audio/video multi-channel receiver
Hide thumbs Also See for VSX-916-K:
Table of Contents

Advertisement

Available languages

Available languages

04

Connecting up

Chapter 4:
Connecting up

Making cable connections

Important
• Before making or changing connections,
switch off the power and disconnect the
power cord from the AC outlet.
• Make sure not to bend the cables over the
top of this unit. If this happens, the
magnetic field produced by the
transformers in this unit may cause a
humming noise from the speakers.
• Before unplugging the power cord, switch
the power into standby.

Analog audio cables

Use stereo RCA phono cables to connect
analog audio components. These cables are
typically red and white, and you should
connect the red plugs to R (right) terminals
and white plugs to L (left) terminals.
Right (red)

Digital audio cables

Commercially available coaxial digital audio
cables or optical cables should be used to
connect digital components to this receiver.
Coaxial digital audio cable
Note
1 • When connecting optical cables, be careful when inserting the plug not to damage the shutter protecting the optical socket.
• When storing optical cable, coil loosely. The cable may be damaged if bent around sharp corners.
• You can also use a standard RCA video cable for coaxial digital connections.
12
En
Analog audio cables
Left (white)
Optical cable

Video cables

Standard RCA video cables
These cables are the most common type of
video connection and are used to connect to
the composite video terminals. The yellow
plugs distinguish them from cables for audio.
Standard RCA video cable
S-video cables
S-video cables give you a clearer picture
reproduction than standard RCA video cables
by sending separate signals for the luminance
and color.
Component video cables
Use component video cables to get the best
possible color reproduction of your video
source. The color signal of the TV is divided into
the luminance (Y) signal and the color (P
P
) signals and then output. In this way,
R
interference between the signals is avoided.
Component video cables
1
Green (Y)
Blue (P
B
)
B
Red (P
)
R
and

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

This manual is also suitable for:

Vsx-916-s

Table of Contents