Making Recordings; Making An Audio Or A Video Recording - Pioneer VSX-916-K Operating Instructions Manual

Making recordings

Chapter 10:
Making recordings
Making an audio or a video
recording
You can make an audio or a video recording
from the built-in tuner, or from an audio or
video source connected to the receiver (such
as a CD player or TV).
Keep in mind you can't make a digital
recording from an analog source or vice-versa,
so make sure the components you are
recording to/from are hooked up in the same
way (see Connecting up on page 12 for more on
connections).
If you want to record a video source, you also
need to use the same type of connection for the
source as for the recorder. For example, you
can't record a component hooked up to S-video
jacks with a recorder hooked up to the
composite video outputs (see page 16 for more
on video connections).
SYSTEM OFF
RECEIVER
INPUT SOURCE
SELECT
DVD TV DVR TV CTRL
CD-R/TAPE USB
CD FM AM RECEIVER
SLEEP SB h ANALOG
1 Select the source you want to record.
Use the MULTI CONTROL buttons (or INPUT
SELECT).
Note
1 • The receiver's volume, balance, tone (bass, treble, loudness), and surround effects have no effect on the recorded signal.
• Some digital sources are copy-protected, and can only be recorded in analog.
• Some video sources are copy-protected. These cannot be recorded.
INPUT
TV CH
TV VOL VOL
SELECT
REC
A
MUTE
MPX EON REC STOP JUKEBOX
B C D E
AUDIO SUBTITLE HDD DVD
DISP CH CH
STANDARD ADV.SURR STEREO AUTO SURR
MULTI OPE S.RETRIEVER ACOUSTIC EQ SIGNAL SEL
SHIFT EFFECT/CH SEL
2 Select the input signal (if necessary).
Press SIGNAL SEL to select the input signal
corresponding to the source component (see
page 33 for more on this).
3 Prepare the source you want to record.
Tune to the radio station, load the CD, video,
DVD etc.
4 Prepare the recorder.
Insert a blank tape, MD, video etc. into the
recording device and set the recording levels.
Refer to the instructions that came with the
recorder if you are unsure how to do this. Most
video recorders set the audio recording level
automatically—check the component's
instruction manual if you're unsure.
5 Start recording, then start playback of the
1
source component.
10
49
En