Selecting Preset Codes Directly; Programming Signals From Other Remote; Controls - Pioneer VSX-916-K Operating Instructions Manual

Controlling the rest of your system

Selecting preset codes directly

SYSTEM OFF
RECEIVER INPUT
SOURCE
SELECT
DVD TV DVR TV CTRL
CD-R/TAPE USB
CD FM AM RECEIVER
SLEEP SB ch ANALOG
ATT
1 While pressing the RECEIVER button,
press the SETUP button.
The remote LCD display shows SETUP.
2 Use to select PRESET then press
ENTER .
3 Press the MULTI CONTROL button for the
component you want to control then press
ENTER .
The LCD on the remote displays the
component you want to control.
4 Use to select the first letter of the
brand name of your component then press
ENTER .
This should be the manufacturer's name (for
example, P for Pioneer).
5 Use to select the manufacturer's
name from the list then press ENTER .
6 Use to select the proper code from
the list, then try using this remote control
with your component.
The code should start with the component type
(for example, DVD 009). If there is more than
one, start with the first one.
Note
1 You can't assign the RECEIVER button.
2 • You can't assign the RECEIVER button.
• TV CONTROL buttons (TV ,TV VOL +/–, TV CH +/– and INPUT SELECT) can only be learned after selecting TV CONT.
SR+ DIMMER MIDNIGHT/
LOUDNESS
DIALOG E
D.ACCESS CLASS
+10
DISC
ENTER
TOP MENU MENU
TUNE
ST ST T.EDIT
ENTER
SETUP
RETURN
TUNE
PTY SEARCH
GUIDE
TV CONTROL
INPUT
TV VOL TV CH VOL
SELECT
1
To try out the remote control, switch the
component on or off (into standby) by pressing
SOURCE
. If it doesn't seem to work, select
the next code from the list (if there is one).
7 If your component is controlled
successfully, press ENTER to confirm.
The remote LCD display shows OK.
Programming signals from other
remote controls
If the preset code for your component is not
available, or the available preset codes do not
operate correctly, you can program signals
from the remote control of another
component. This can also be used to program
additional operations (buttons not covered in
the presets) after assigning a preset code.
1 While pressing the RECEIVER button,
press the SETUP button.
The remote LCD display shows SETUP.
2 Use to select LEARNING then press
ENTER .
3 Press the MULTI CONTROL button for the
component you want to control then press
ENTER .
The LCD on the remote displays the
component you want to control.
PRES KEY shows in the LCD display.
4 Point the two remote controls towards
each other then press the button that will be
doing the learning on this receiver's remote
control.
PRES KEY starts flashing to indicate the
remote is ready to accept a signal.
11
2
51
En