Making Recordings; Making An Audio Or A Video Recording - Pioneer VSX-1014-S Operating Instructions Manual

Making recordings

Chapter 8:
Making recordings

Making an audio or a video recording

You can make an audio or a video recording from the
built-in tuner, or from an audio or video source
connected to the receiver (such as a CD player or TV).
Keep in mind you can't make a digital recording from an
analog source or vice-versa, so make sure the
components you are recording to/from are hooked up in
the same way (see Connecting up on page 14 for more on
connections).
If you want to record a video source, you also need to use
the same type of connection for the source as for the
recorder. For example, you can't record a component
hooked up to S-video jacks with a recorder hooked up to
the composite video outputs (see page 18 for more on
video connections).
INPUT
RECEIVER SOURCE
SELECT
DVD/LD TV/SAT DVR/VCR TV CONT
MULTI CONTROL
CD CD-R/TAPE TUNER RECEIVER
TUNER
TUNING/ MIDNIGHT/
EDIT
STATION BAND MPX LOUDNESS
TUNER
CONTROL MULTI
JOG
MULTI ROOM
SYSTEM
SETUP RETURN CONTROL ON/OFF
MULTI JOG MULTI JOG
PHONES
The illustration above shows the VSX-2014i-G model.
INPUT
TV VOL TV CH VOL
SELECT
DTV ON/OFF REC DTV INFO MUTE
TUNER
REC STOP
DISPLAY
MPX CH RETURN
HDD DVD
AUDIO SUBTITLE
CH CH
RECEIVER CONTROL
THX STANDARD ADV.SURR STEREO
ACOUSTIC SIGNAL MIDNIGHT/
AUTO SURR EQ SELECT LOUDNESS
EFFECT
SHIFT SLEEP DIALOG E
/CH SEL
RECEIVER
DVD/LD TV/SAT DVR/VCR VIDEO1
CD-R/
CD TAPE/MD TUNER VIDEO2
MASTER VOLUME
ACOUSTIC i.LINK MULTI CH SIGNAL EXTENDED
SPEAKERS
TONE EQ SELECT IN SELECT MODE
MULTI MULTI
JOG JOG
VIDEO2 INPUT
MCACC
SETUP MIC
DIGITAL IN S-VIDEO VIDEO L AUDIO R
1 Select the source you want to record.
Use the MULTI CONTROL buttons (or INPUT SELECT).
2 Select the input signal (if necessary).
Press SIGNAL SELECT to select the input signal
corresponding to the source component (see page 33 for
more on this).
3 Prepare the source you want to record.
Tune to the radio station, load the CD, video, DVD etc.
4 Prepare the recorder.
Insert a blank tape, MD, video etc. into the recording
device and set the recording levels.
Refer to the instructions that came with the recorder if
you are unsure how to do this. Most video recorders set
the audio recording level automatically—check the
component's instruction manual if you're unsure.
5 Start recording, then start playback of the source
component.
Note
• The receiver's volume, balance, tone (bass, treble,
loudness), and surround effects have no effect on the
recorded signal.
• Some digital sources are copy-protected, and can
only be recorded in analog.
• Some video sources are copy-protected. These
cannot be recorded.
08
49
En