Video - Pioneer PDK-1014 Operating Instructions Manual

Additional information
12
Symptom
Can't record audio.
Subwoofer output is very low.
The signal is not downmixed
when listening to a multichannel
DVD-Audio disc (for example,
you only hear the front left and
right channels when listening in
stereo).
Everything seems to be set up
correctly, but the playback sound
is odd.
Noise or hum can be heard even
when there is no sound being
input.
There seems to be a time lag
between the speakers and the
output of the subwoofer.
The maximum volume available
(shown in the front panel display)
is lower than the +12dB
maximum.

Video

Symptom
No image is output when an
input is selected.
76
En
Cause
• You are trying to make an analog recording
from a digital signal, or a digital recording of
an analog source.
• The digital source is copy protected.
• The analog REC jacks have not been
connected properly.
• The speaker settings result in very little
audio signal being sent to the subwoofer.
• The disc is downmix prohibited.
• The speakers are out of phase.
• There is electrical interference from another
component or appliance.
• The subwoofer channel can be delayed
slightly if run through a low-pass filter.
• The channel levels may have been adjusted. • This is not a malfunction. If the levels in Channel Level
Cause
• The video connections are incorrect.
• You are using component video
connections for your source, but not for your
TV.
• You are using component video
connections and the component video inputs
are assigned incorrectly.
• The DVD/video player settings are incorrect. • Set correctly. Refer to the instruction manual supplied
• The video input selected on the TV monitor
is incorrect.
• Even though the sub room monitor is
connected properly, the multi-room feature is
switched off.
• The component video inputs are assigned
to a video component connected only to the
composite or S-Video terminals.
• You connected your TV to the MULTI ROOM
& SOURCE MONITOR OUT jack instead of
the main MONITOR OUT jack.
Remedy
• You can only record analog to analog, or digital to
digital.
• You can't record digital sources that have been copy
protected.
• Check your analog connections (see Connecting analog
audio components on page 17).
• To route more audio signal to the subwoofer, set it to
PLUS, or select SMALL for the front speaker setting (see
Speaker Setting on page 44).
• This is not a malfunction.
• Check that the positive/negative speaker terminals on
the receiver are matched with the corresponding
terminals on the speakers (see Connecting the speakers
on page 20).
• Check that personal computers or other digital
components connected to the same power source are not
causing interference.
• See Automatically setting up for surround sound
(MCACC) on page 11 to set up your system again using
MCACC (this will automatically compensate for a delay in
the subwoofer output).
on page 45 have been adjusted, the maximum volume will
change accordingly.
Remedy
• Make sure the video component is connected correctly
(see page 18).
• Using the video converter, video signals can be
converted from a composite or S-video input to a
component video output, but not vice-versa (VSX-2014i
only). See About the video converter on page 15 for more
on this.
• Check Assigning the component video inputs on page 68
to make sure you're assigned the correct input.
with the DVD/video player.
• Set correctly. Refer to the instruction manual supplied
with the TV.
• Press the MULTI ROOM&SOURCE ON/OFF button to
switch it on.
• Check Assigning the component video inputs on page 68
to make sure the component video assign for that video
component is switched to OFF.
• Connect the MONITOR OUT jack to the TV monitor (see
Connecting video components on page 18).