Making Recordings; Making An Audio Or A Video Recording - Pioneer PDK-1014 Operating Instructions Manual

Making recordings

08
Chapter 8:
Making recordings

Making an audio or a video recording

You can make an audio or a video recording from the
built-in tuner, or from an audio or video source
connected to the receiver (such as a CD player or TV).
Keep in mind you can't make a digital recording from an
analog source or vice-versa, so make sure the
components you are recording to/from are hooked up in
the same way (see Connecting up on page 14 for more on
connections).
If you want to record a video source, you also need to use
the same type of connection for the source as for the
recorder. For example, you can't record a component
hooked up to S-video jacks with a recorder hooked up to
the composite video outputs (see page 18 for more on
video connections).
INPUT
RECEIVER
SELECT
DVD/LD TV/SAT
MULTI CONTROL
CD CD-R/TAPE
TUNER TUNING/
EDIT
STATION
TUNER
CONTROL MULTI
JOG
SYSTEM
SETUP RETURN CONTROL
MULTI JOG MULTI JOG
PHONES
The illustration above shows the VSX-2014i model.
52
En
INPUT
TV CH
TV VOL
SELECT
SOURCE
REC
A
TUNER
REC STOP
DISPLAY
B C D
MPX CH RETURN
HDD
AUDIO SUBTITLE
CH
RECEIVER CONTROL
THX STANDARD ADV.SURR
ACOUSTIC SIGNAL MIDNIGHT/
DVR/VCR TV CONT AUTO SURR EQ SELECT LOUDNESS
EFFECT
SLEEP DIALOG E
SHIFT
/CH SEL
TUNER RECEIVER
RECEIVER
DVD/LD TV/SAT DVR/VCR VIDEO1
CD-R/
CD TAPE/MD TUNER VIDEO2
MASTER VOLUME
PTY
ACOUSTIC i.LINK MULTI CH SIGNAL
BAND EON TONE
SEARCH EQ SELECT IN SELECT
MULTI MULTI MULTI
JOG JOG JOG
VIDEO2 INPUT
MULTI ROOM
MCACC
ON/OFF
SETUP MIC
DIGITAL IN S-VIDEO VIDEO
1 Select the source you want to record.
Use the MULTI CONTROL buttons (or INPUT SELECT).
2 Select the input signal (if necessary).
Press SIGNAL SELECT to select the input signal
corresponding to the source component (see page 33 for
more on this).
3 Prepare the source you want to record.
Tune to the radio station, load the CD, video, DVD etc.
4 Prepare the recorder.
Insert a blank tape, MD, video etc. into the recording
device and set the recording levels.
Refer to the instructions that came with the recorder if
you are unsure how to do this. Most video recorders set
the audio recording level automatically—check the
component's instruction manual if you're unsure.
VOL
5 Start recording, then start playback of the source
component.
MUTE
E
DVD
Note
CH
STEREO
• The receiver's volume, balance, tone (bass, treble,
loudness), and surround effects have no effect on the
recorded signal.
• Some digital sources are copy-protected, and can
only be recorded in analog.
• Some video sources are copy-protected. These
cannot be recorded.
EXTENDED
SPEAKERS
MODE
L AUDIO R