Configuring Bgp Load Balancing - HP 5500 EI series Configuration Manual

Step
1. Enter system view.
2. Enter BGP view or BGP-VPN
instance view.
3. Enable MD5 authentication
for a BGP peer group or peer.
To enable MD5 authentication for BGP peers (IPv6):
Step
1. Enter system view.
2. Enter BGP view or BGP-VPN
instance view.
3. Enable MD5 authentication
for a BGP peer group or peer.

Configuring BGP load balancing

Perform this task to specify the maximum number of BGP ECMP routes for load balancing.
To specify the maximum number of BGP ECMP routes for load balancing (IPv4):
Step
1. Enter system view.
2. Enter BGP view or BGP-VPN
instance view.
3. Enter BGP IPv4 unicast
address family view or
BGP-VPN IPv4 unicast
address family view.
Command
system-view
•
Enter BGP view:
bgp as-number
•
Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
peer { group-name | ip-address }
password { cipher | simple }
password
Command
system-view
•
Enter BGP view:
bgp as-number
•
Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
peer { group-name |
ipv6-address } password { cipher |
simple } password
Command
system-view
•
Enter BGP view:
bgp as-number
•
Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
address-family ipv4 [ unicast ]
228
Remarks
N/A
Use either method.
By default, MD5 authentication is
disabled.
Remarks
N/A
Use either method.
By default, MD5 authentication is
disabled.
Remarks
N/A
N/A
N/A