HP 5500 EI series Configuration Manual page 289

Session State: Up
Min Tx Inter: 500ms
Min Rx Inter: 500ms
Rx Count: 135
Connect Type: Indirect
Hold Time: 2457ms
Detect Mode: Async
Protocol: BGP
Diag Info: No Diagnostic
The output shows that a BFD session has been established between Router A and Router C.
# Display BGP peer information on Router C.
<RouterC> display bgp peer ipv4
BGP local router ID: 3.3.3.3
Local AS number: 200
Total number of peers: 2
Peer
2.0.1.1
3.0.1.1
The output shows that Router C has established two BGP connections with Router A, and both
connections are in Established state.
# Display route 1.1.1.0/24 on Router C.
<RouterC> display ip routing-table 1.1.1.0 24 verbose
Summary Count : 1
Destination: 1.1.1.0/24
Protocol: BGP
SubProtID: 0x1
Cost: 50
Tag: 0
OrigTblID: 0x1
TableID: 0x2
NBRID: 0x15000001
AttrID: 0x1
Flags: 0x10060
Label: NULL
BkLabel: NULL
Tunnel ID: Invalid
BkTunnel ID: Invalid
The output shows that Router C communicates with network 1.1.1.0/24 through the path Router
C<—>Router B<—>Router A.
# Break down the link Router C<—>Router B<—>Router A and then display route 1.1.1.0/24 on Router
C.
Act Tx Inter: 500ms
Detect Inter: 2500ms
Running Up for: 00:00:58
Peers in established state: 2
AS MsgRcvd MsgSent OutQ PrefRcv Up/Down
200 4
200 4
Process ID: 0
Age: 00h00m09s
Preference: 255
State: Active Adv
OrigVrf: default-vrf
OrigAs: 0
LastAs: 0
Neighbor: 3.0.1.1
OrigNextHop: 3.0.1.1
RealNextHop: 3.0.2.1
BkNextHop: N/A
Interface: Ethernet1/1
BkInterface: N/A
278
Interface: N/A
Tx Count: 135
Auth mode: None
Slot: 0
5 0 0 00:01:55 Established
5 0 0 00:01:52 Established
State