HP 5500 EI series Configuration Manual page 312

Step Command
5. Set VPN
apply access-vpn vpn-instance
instances.
vpn-instance-name&<1-n>
apply next-hop [ vpn-instance
vpn-instance-name | inbound-vpn ]
6. Set next hops.
{ ip-address [ direct ] [ track
track-entry-number ] }&<1-n>
7. Enable load
sharing
among
apply loadshare next-hop
multiple next
hops.
apply output-interface { interface-type
8. Set output
interface-number [ track
interfaces.
track-entry-number ] }&<1-n>
9. Enable load
sharing
among
apply loadshare output-interface
multiple output
interfaces.
apply default-next-hop [ vpn-instance
10. Set default
vpn-instance-name | inbound-vpn ]
next hops.
{ ip-address [ direct ] [ track
track-entry-number ] }&<1-n>
11. Enable load
sharing
among
apply loadshare default-next-hop
multiple
default next
hops.
Remarks
By default, no VPN instance is
specified.
You can specify up to m VPN instances
for a node. The matching packets are
forwarded according to the
forwarding table of the first available
VPN instance. The value of m depends
on the device model.
By default, no next hop is specified.
You can specify multiple next hops for
backup or load sharing by executing
this command once or multiple times.
You can specify up to m next hops for
a node. The value of m depends on the
device model.
By default, the next hops operate in
primary/backup mode.
By default, no output interface is
specified.
You can specify multiple output
interfaces for backup or load sharing
by executing this command once or
multiple times.
You can specify up to m output
interfaces for a node. The value of m
depends on the device model.
By default, the output interfaces
operate in primary/backup mode.
By default, no default next hop is
specified.
You can specify multiple default next
hops for backup or load sharing by
executing this command once or
multiple times.
You can specify up to m default next
hops for a node. The value of m
depends on the device model.
By default, the default next hops
operate in primary/backup mode.
301