Configuring Rip Frr - HP 5500 EI series Configuration Manual

# Display RIP routes destined for 100.1.1.0/24 on Router A when the link between Router B and
Router C fails.
<RouterA> display ip routing-table 100.1.1.0 verbose
Summary Count : 1
Destination: 100.1.1.0/24
Protocol: RIP
SubProtID: 0x1
OrigTblID: 0x0
TableID: 0x2
AttrID: 0xffffffff
BkLabel: NULL
Tunnel ID: Invalid
BkTunnel ID: Invalid

Configuring RIP FRR

Network requirements
As shown in
A becomes unidirectional, traffic can be switched to Link B immediately.
Figure 14 Network diagram
Configuration procedure
1. Configure IP addresses and subnet masks for interfaces on the routers. (Details not shown.)
2. Configure RIPv2 on the routers to make sure Router A, Router D, and Router S can communicate
with each other at the network layer. (Details not shown.)
3. Configure RIP FRR:
# Configure Router S.
<RouterS> system-view
[RouterS] bfd echo-source-ip 1.1.1.1
[RouterS] ip prefix-list abc index 10 permit 4.4.4.4 32
[RouterS] route-policy frr permit node 10
Cost: 2
Tag: 0
NBRID: 0x12000003
Flags: 0x1008c
Label: NULL
Figure 14, Router S, Router A, and Router D run RIPv2. Configure RIP FRR so that when Link
Process ID: 2
Age: 00h10m35s
Preference: 100
State: Active Adv
OrigVrf: default-vrf
OrigAs: 0
LastAs: 0
Neighbor: 192.168.3.2
OrigNextHop: 192.168.3.2
RealNextHop: 192.168.3.2
BkNextHop: N/A
Interface: Ethernet1/2
BkInterface: N/A
55