Generating Bgp Routes; Injecting A Local Network - HP 5500 EI series Configuration Manual

Step
2. Enter BGP view or BGP-VPN
instance view.
3. Specify the source interface
for establishing TCP
connections to a peer or peer
group.
To specify the source interface for TCP connections (IPv6):
Step
1. Enter system view.
2. Enter BGP view or BGP-VPN
instance view.
3. Specify the source interface
for establishing TCP
connections to a peer or peer
group.

Generating BGP routes

BGP can generate routes in the following ways:
• Advertise local networks.
Redistribute IGP routes.
•

Injecting a local network

Perform this task to inject a network in the local routing table to the BGP routing table, so BGP can
advertise the network to BGP peers. The ORIGIN attribute of BGP routes advertised in this way is IGP.
You can also use a routing policy to control route advertisement.
The specified network must be available and active in the local IP routing table.
To inject a local network (IPv4):
Command
•
Enter BGP view:
bgp as-number
•
Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
peer { group-name | ip-address }
connect-interface interface-type
interface-number
Command
system-view
•
Enter BGP view:
bgp as-number
•
Enter BGP-VPN instance view:
a. bgp as-number
b. ip vpn-instance
vpn-instance-name
peer { group-name |
ipv6-address } connect-interface
interface-type interface-number
197
Remarks
N/A
By default, BGP uses the outbound
interface of the best route to the
BGP peer or peer group as the
source interface for establishing a
TCP connection to the peer or peer
group.
Remarks
N/A
N/A
By default, BGP uses the outbound
interface of the best route to the
BGP peer or peer group as the
source interface for establishing a
TCP connection to the peer or peer
group.