Table of Contents
Advertisement
Alarm: Alarm
The functions available here
allow you to customize and
configure how you would like
your NVR to interpret from
and respond to the alarm
panel (up to eight alarm in-
puts and one alarm output
available) located at the rear
of your NVR.
Alarm In:
The connection that corresponds to the input you've connected the
sensor to. Click the drop down menu to select.
Alarm Type:
Whether the sensor is Normally-Open or Normally-Close.
Please check the documentation that came with your sensor then click the
drop down menu to select the appropriate setting.
Latch Time:
If you have an alarm device connected to the alarm output (such
as a siren), you can control how long it will be active for when one or more
alarm sensors have been triggered.
Buzzer:
When one or more alarm sensors have been triggered, you can ena-
ble the NVR's buzzer to alert you for a predetermined amount of time.
Post Recording:
This option instructs your NVR to record for a set period of
time after an event has occurred. For most instances, the default selection
Click for contents
will be suitable, however you can change this if you wish.
Alarm Out:
Click the checkbox to enable the alarm output when one or more
alarm sensors have been triggered.
Show Message:
When one or more alarm sensors have been triggered, a
message will appear on-screen. Click the checkbox to disable this.
Send Email:
Click the checkbox to enable your NVR to send an email alert
when one or more alarm sensors have been triggered.
Full Screen:
Click the checkbox to view the camera full screen in Live View
mode when one or more alarm sensors have been triggered.
(continued on next page)
· Don't forget to click "Save"
to apply settings.
· Click the "Default" button to
revert back to default settings.
· Click the "Close" button to
exit the Main Menu.
58
Advertisement
Table of Contents
