Table of Contents
Advertisement
Network: Network
As SwannLink Peer-to-Peer
technology is utilised to com-
municate with your network
and mobile device, config-
uration of the network set-
tings is not required. If you
have networking expertise
and require specific settings
for your network, you do have
the ability to change them.
PPPoE:
Allows your NVR to be directly connected to a DSL modem. When
selecting this option, you need to input the user name, password and DNS
settings for your internet service provider.
DHCP (Dynamic Host Configuration Protocol):
assign an IP address to each device connected to your network. This is ena-
bled by default.
Static:
All devices on your network have their IP address manually defined.
Server Port:
This port number is used by your NVR to send information
through. The default number will work in most situations.
HTTP Port:
This port number is used to log into your NVR from a remote lo-
cation. The default number will work in most situations.
Click for contents
Your router will automatically
The following five options can be changed when selecting Static:
IP Address:
Each device on your network must have a unique IP address. A
typical address might be "192.168.1.24" or something similar.
Subnet Mask:
This allows the flow of network traffic between hosts to be
segregated based on a network configuration. A typical address might be
"255.255.255.0" or something similar.
Gateway:
This allows your NVR to connect to the internet. This is typically the
same IP address as your modem or router.
DNS (Domain Name System)1/2:
service provider.
(continued on next page)
· Don't forget to click "Save"
to apply settings.
· Click the "Default" button to
revert back to default settings.
· Click the "Close" button to
exit the Main Menu.
Input the DNS settings for your internet
51
Advertisement
Table of Contents
