Siemens SIMATIC ET 200SP Manual page 14

Parameters/address space
4.2 Parameters
Parameter
Interference frequency
suppression
Potential group
Only when configuring using a PROFIBUS GSD file; does not apply to configuration with STEP 7 via HSP: The parame-
1
ter assignment options are limited because PROFIBUS GSD configuration limits the number of parameters to a maxi-
mum of 244 bytes for each ET 200SP station. If required, you can still assign this parameter using the data record 128
as described in the column "GSD file PROFINET IO" (see table above). The parameter length of the I/O module is 8
bytes.
Interference frequency suppression: Noise at 400 Hz is automatically included in the filtering at 50 Hz.
2
By selecting this interference frequency suppression with shorter integration time, the attenuation of the interference
3
frequency that can be achieved is reduced (see Technical specifications).
Note
Unused channels
Disable unused channels in the parameter assignment to improve the cycle time of the
module.
A deactivated channel always returns the value 7FFF
14
Range of values
60 Hz (50 ms)
•
50 Hz (60 ms)
• 2
16.6 Hz (180 ms)
•
4800 Hz (0.625 ms)
•
60 Hz (18.75 ms)
• 3
50 Hz (22.5 ms)
• 2 3
16.6 Hz (67.5 ms)
• 3
Use potential group of the
•
left module (dark-colored
BaseUnit)
Enable new potential
•
group (light-colored Ba-
seUnit)
Default Reconfigura-
tion in RUN
50 Hz (60 ms) Yes
Use potential No
group of the
left module
.
H
Analog input module AI 8xU BA (6ES7134-6FF00-0AA1)
Effective range with configura-
tion software, e.g. STEP 7
(TIA Portal)
GSD file GSD file
PROFINET PROFIBUS DP
IO
Channel Module
Module Module
Manual, 03/2015, A5E34941660-AA