Enabling Lldp Polling; Configuring The Advertisable Tlvs - HP 3600 v2 series Configuration Manual

To do...
Enter system view
Set the LLDP re-initialization delay

Enabling LLDP polling

With LLDP polling enabled, a device periodically searches for local configuration changes. On detecting
a configuration change, the device sends LLDPDUs to inform neighboring devices of the change.
Follow these steps to enable LLDP polling:
To do...
Enter system view
Enter Ethernet
interface view
or port group
view
Enable LLDP polling and set the polling
interval

Configuring the advertisable TLVs

Follow these steps to configure the advertisable LLDPDU TLVs on the specified port or ports:
To do...
Enter system view
Enter
Ethernet
interface
view or
port group
view
Configure the advertisable TLVs
(Layer 2 Ethernet interface view
or port group view)
Use the command...
system-view
lldp timer reinit-delay delay
Enter Layer 2/Layer 3
Ethernet interface view
Enter port group view
Use the command...
system-view
Enter Layer
2/Layer 3
interface interface-type interface-number
Ethernet interface
view
Enter port group
port-group manual port-group-name
view
lldp tlv-enable { basic-tlv { all |
port-description | system-capability |
system-description | system-name } |
dot1-tlv { all | port-vlan-id |
protocol-vlan-id [ vlan-id ] | vlan-name
[ vlan-id ] } | dot3-tlv { all | link-aggregation
| mac-physic | max-frame-size | power } |
med-tlv { all | capability | inventory |
location-id { civic-address device-type
country-code { ca-type ca-value }&<1–10> |
elin-address tel-number } | network-policy |
power-over-ethernet } }
Use the command...
system-view
interface interface-type
interface-number
port-group manual port-group-name
lldp check-change-interval interval
222
Remarks
—
Optional
2 seconds by default.
Remarks
—
Required
Use either command.
Required
Disabled by default.
Remarks
—
Required
Use either command.
Optional
By default, all types of LLDP
TLVs except location
identification TLVs are
advertisable on a Layer 2
Ethernet port.