HP 3600 v2 series Configuration Manual page 197

Configure the edge and third-party devices to allow the voice traffic and data traffic to be
•
transmitted between the two companies via SVLAN 100 SVLAN 200 separately.
Figure 62 Network diagram
Company A
VLAN 10
Configuration procedure
NOTE:
Be sure that you have configured the switches in the service provider network to allow QinQ packets to
pass through.
Configure PE 1.
1.
• Configure Ethernet 1/0/1.
# Configure Ethernet 1/0/1 as a hybrid port to permit frames of VLAN 100 and VLAN 200 to pass
through untagged.
<PE1> system-view
[PE1] interface ethernet 1/0/1
[PE1-Ethernet1/0/1] port link-type hybrid
[PE1-Ethernet1/0/1] port hybrid vlan 100 200 untagged
[PE1-Ethernet1/0/1] quit
# Create class A10 and configure the class to match frames with CVLAN 10.
[PE1] traffic classifier A10
[PE1-classifier-A10] if-match customer-vlan-id 10
[PE1-classifier-A10] quit
# Create traffic behavior P100 and add the action of inserting outer VLAN tag 100.
[PE1] traffic behavior P100
[PE1-behavior-P100] nest top-most vlan-id 100
[PE1-behavior-P100] quit
# Create class A20 and configure the class to match frames with CVLAN 20. Create traffic behavior
P200 and add the action of inserting outer VLAN tag 200.
[PE1] traffic classifier A20
PE 1
Eth1/0/2
VLANs 100, 200
Eth1/0/1
CE 1
VLAN 20
Eth1/0/2
TPID = 0x8200
Public network
VLAN 30
189
PE 2
Eth1/0/1
Company B
CE 2
VLAN 40