HP 3600 v2 series Configuration Manual page 109

# Enter MST region view, configure the MST region name as example, map VLAN 10, VLAN 30, and
VLAN 40 to MSTI 1, MSTI 3, and MSTI 4 respectively, and configure the revision level of the MST region
as 0.
<DeviceC> system-view
[DeviceC] stp region-configuration
[DeviceC-mst-region] region-name example
[DeviceC-mst-region] instance 1 vlan 10
[DeviceC-mst-region] instance 3 vlan 30
[DeviceC-mst-region] instance 4 vlan 40
[DeviceC-mst-region] revision-level 0
# Activate MST region configuration.
[DeviceC-mst-region] active region-configuration
[DeviceC-mst-region] quit
# Specify the current device as the root bridge of MSTI 4.
[DeviceC] stp instance 4 root primary
# Enable the spanning tree feature globally.
[DeviceC] stp enable
Configure Device D.
5.
# Enter MST region view, configure the MST region name as example, map VLAN 10, VLAN 30, and
VLAN 40 to MSTI 1, MSTI 3, and MSTI 4 respectively, and configure the revision level of the MST region
as 0.
<DeviceD> system-view
[DeviceD] stp region-configuration
[DeviceD-mst-region] region-name example
[DeviceD-mst-region] instance 1 vlan 10
[DeviceD-mst-region] instance 3 vlan 30
[DeviceD-mst-region] instance 4 vlan 40
[DeviceD-mst-region] revision-level 0
# Activate MST region configuration.
[DeviceD-mst-region] active region-configuration
[DeviceD-mst-region] quit
# Enable the spanning tree feature globally.
[DeviceD] stp enable
Verify the configurations
6.
You can use the display stp brief command to display brief spanning tree information on each device
after the network is stable.
# Display brief spanning tree information on Device A.
[DeviceA] display stp brief
MSTID Port
0 Ethernet1/0/1
0 Ethernet1/0/2
0 Ethernet1/0/3
1 Ethernet1/0/1
1 Ethernet1/0/3
3 Ethernet1/0/2
Role STP State
ALTE DISCARDING
DESI FORWARDING
ROOT FORWARDING
DESI FORWARDING
DESI FORWARDING
DESI FORWARDING
101
Protection
NONE
NONE
NONE
NONE
NONE
NONE