Protocols And Standards; Configuring Basic Vlan Settings - HP 3600 v2 series Configuration Manual

Other criteria
•
The 3600 v2 Switch Series supports port-based VLAN, MAC-based VLAN, protocol-based VLAN, and
IP-based VLAN. The port-based VLAN implementation is the basis of all other VLAN implementations. To
use any other VLAN implementations, you must configure port-based VLAN settings.
You can configure all these types of VLANs on a port at the same time. When the switch is determining
which VLAN a packet that passes through the port should be assigned to, it looks up the VLANs in the
default order of MAC-based VLAN, IP-based VLAN, protocol-based VLAN, and port-based VLAN.

Protocols and standards

IEEE 802.1Q, IEEE Standards for Local and Metropolitan Area Networks: Virtual Bridged Local
•
Area Networks

Configuring basic VLAN settings

Follow these steps to configure basic VLAN settings:
To do...
Enter system view
Create VLANs
Enter VLAN view
Configure a name for the
VLAN
Configure the description of
the VLAN
NOTE:
• As the default VLAN, VLAN 1 cannot be created or removed.
You cannot manually create or remove VLANs reserved for special purposes.
•
To delete a protocol reserved VLAN, voice VLAN, management VLAN, dynamic VLAN, VLAN with a
•
QoS policy applied, control VLAN for a smart link group, control VLAN for an RRPP domain, remote
probe VLAN for remote port mirroring, remove the configuration from the VLAN first, and execute the
undo vlan command.
Use the command...
system-view
vlan { vlan-id1 [ to vlan-id2 ] |
all }
vlan vlan-id
name text
description text
116
Remarks
—
Optional
Use this command to create VLANs in bulk.
Required
By default, only the default VLAN (VLAN 1)
exists in the system.
If the specified VLAN does not exist, this
command creates the VLAN first.
Optional
By default, the name of a VLAN is its VLAN
ID (VLAN 0001, for example).
Optional
VLAN ID is used by default (VLAN 0001,
for example).