HP 3600 v2 series Configuration Manual page 222

# Set customer-side port Ethernet 1/0/1 as a trunk port, assign it to VLAN 200, and apply uplink policy
down_uplink to the incoming traffic and downlink policy down_downlink to the outgoing traffic on the
port.
[PE3] interface ethernet 1/0/1
[PE3-Ethernet1/0/1] port link-type trunk
[PE3-Ethernet1/0/1] port trunk permit vlan 200
[PE3-Ethernet1/0/1] qos apply policy down_uplink inbound
[PE3-Ethernet1/0/1] qos apply policy down_downlink outbound
[PE3-Ethernet1/0/1] quit
# Set network-side port Ethernet 1/0/2 as a trunk port, assign it to VLAN 200, and apply uplink policy
up_uplink to the outgoing traffic on the port.
[PE3] interface ethernet 1/0/2
[PE3-Ethernet1/0/2] port link-type trunk
[PE3-Ethernet1/0/2] port trunk permit vlan 200
[PE3-Ethernet1/0/2] qos apply policy up_uplink outbound
[PE3-Ethernet1/0/2] quit
Configuring PE 4.
4.
# Configure QinQ function on Ethernet 1/0/2 to add outer VLAN tag 200 to the traffic tagged with
VLAN 30.
<DeviceD> system-view
[DeviceD] interface ethernet 1/0/2
[DeviceD-Ethernet1/0/2] port access vlan 200
[DeviceD-Ethernet1/0/2] qinq enable
# Configure Ethernet 1/0/1 to permit frames of VLAN 200 to pass through.
[DeviceD] interface ethernet 1/0/1
[DeviceD-Ethernet1/0/1] port link-type trunk
[DeviceD-Ethernet1/0/1] port trunk permit vlan 200
214