Microphone Transmitters - Shure MXW Manual

MXW
Color
Red
Amber
Flashing Red
④ Microphone Link Button
Press and hold for 6 seconds to link all microphones in the charger to channels of the associated Access Point Transceiver.
⑤ Battery Status LEDs
Monitors the charge status of the connected microphone in increments of <10, 10, 25, 50, 75, 100% (see Batteries for more detail). Additionally, the five LEDs
flash for several seconds when the microphone has been successfully linked to the channel.
⑥ Locking DC Power Supply
Secures the PS60 power supply to the input jack of the station.
⑦ Power Switch
Powers the unit on or off.
⑧ Ethernet Port
Connects to the MXW System network through an MXW Audio Network Interface or a switch using an Ethernet cable.
⑨ Ethernet Status LED (Green)
• Off = no network link.
• On = network link established.
• Flashing = network link active.
⑩ Ethernet Link Speed LED (Amber)
• Off = 10 Mbps
• On = 100 Mbps
Connecting Microphones
Place a microphone in the charger by connecting it to one of the channel slots. The channels in the top row have two USB ports to accommodate different types
of microphones. Do not attempt to connect to both USB ports at the same time.
Note: 2-channel chargers do not support gooseneck microphones.
• Handheld, boundary and bodypack: use the main vertical slots in the recessed bays.
• Gooseneck base: uses the top row's horizontal connectors.

Microphone Transmitters

Description
① Power Button
MXW6, MXW8: Press and hold the dedicated power button for three seconds to turn the transmitter on or off.
MXW1, MXW2: Press and hold the Mute/Active button for five seconds to turn the transmitter on or off.
② Mute/Active Button
Changes the audio status from Active to Mute, or Mute to Active. The button behavior for each transmitter type can be set independently from the Preferences
tab. The following describes the function of each setting:
• Toggle: Press and release the button to change the status to Active or Mute.
• Push-to-talk: Hold button to pass audio.
• Push-to-mute: Hold button to mute the audio.
• Disabled: The button does not affect the audio.
③ Status LED
Indicates the transmitter's status. The color indicators for Mute and Active can be customized from the Preferences tab. See the Status LED table for the default
LED behavior for MXW transmitters except the gooseneck light-ring models (MX405R/410R/415R).
10/72
Link procedure unsuccessful (RF issue, network failure, or microphones removed during procedure)
Link procedure cannot start because the station is not associated to a group.
Link procedure has been locked from the control software.
Different Connectors for the Same Channel
Indicator
Shure Incorporated
2017/05/17