Fujitsu ASG30LMTA Service Instruction page 67

Trouble shooting 31
OUTDOOR UNIT Error Method:
Discharge Temp. Error
Detective Actuators:
Discharge temperature thermistor
Outdoor unit Main PCB
Forecast of Cause :
<Cooling operation>
Check Point 1 : Check if 3-way valve(gas side) is open.
If the 3-way valve(gas side) was closed, open the
3-way valve(gas side) and check operation.
OK
Check Point 2 : Check the EEV, strainer
EEV open?
Strainer clogging check
(Refer to PARTS INFORMATION 3)
OK
Check Point 3 : Check the outdoor unit fan,heat exchanger
Check for foreign object at heat exchanger
Check if fan can be rotated by hand.
Motor check (PARTS INFORMATION 5)
OK
Check Point 4 : Check the discharge thermistor
Discharger thermistor characteristics check
(Check by disconnecting thermistor from PCB.)
* For the characteristics of the thermistor, refer to the "Trouble shooting 20".
OK
Check Point 5 : Check the refrigerant amount
Leak check
OK
Check Point 6 : Replace Main PCB
If Check Point 1- 5 do not improve the symptom, replace Main PCB.
AMP Air Conditioning
Indicate or Display:
Indoor Unit :
Operation lamp: 10 times Flash,
Timer lamp
Detective details:
"Protection stop by "discharge temperature
operation"" generated 2 times within 24 hours.
1. 3-way valve not opened
3. Outdoor unit operation failure, foreign matter on heat exchanger
4. Discharge temperature thermistor failure
6. Main PCB failure
Wired Remote Controller :
ERROR CODE : [E : A1]
: 1 times Flash
2. EEV defective, strainer clogged
5. Insufficient refrigerant
<Heating operation>
Check Point 1 : Check if 3-way valve(liquid side) is open.
If the 3-way valve(liquid side) was closed, open the
3-way valve(liquid side) and check operation.
OK
Check Point 2 : Check the EEV, strainer
EEV open?
Strainer clogging check
(Refer to PARTS INFORMATION 3)
OK
02-34
www.ampair.co.uk | sales@ampair.co.uk
110degC during compressor