EXCELL PRECISION CO., LTD
CHAPTER 5 MAINTENANCE
5-1 Restore All Parameters To Default Factory Values
(1) While the indicator is counting back to zero, adjust SW to ON and press
(2) Display shows the flashing digits
(3) Confirm / abort
(3-1) To confirm press
then release the key and return the calibration SW to OFF.
(3-2) To abort, press
EX-2005C
.
.
key & don't release it until the display shows
Enter
Run
key to exit.
Stop
⇒ Increase the flash value by one
Limit
F
⇒ Decrease the flash value by one
Qty
⇒ Move the cursor leftward
MR
MC
⇒ Move the cursor rightward
⇒ Confirm key
Enter
Run
⇒ Exit key
Stop
26
F
Enter
,
ZSME300000116