EXCELL PRECISION CO., LTD
5-2-1 7 Segment Display Testing
The display will show
5-2-2 Keypad And Calibration SW Testing
Setting the calibration SW to "ON", or pressing any key will cause the related display
segment to change from
5-2-3 Display A/D Internal Value Display
Display range is 0 ~ 520,000d (-0.1 ~ 4.0 mV/V).
5-2-4 RS-232 Serial Loop Back Testing
Terminal pin 5 and pin 6 must be connected together at the rear of the indicator.
If display shows
If display shows
5-2-5 EEPROM Memory Testing
If the display shows
memory is not working correctly.
5-2-6 IFC Factory Testing (reserved)
5-2-7 RELAY_IO Interface Card Testing
The display shows the indication light of corresponding input pins.
When the input signal and IN_COM is short, the bit indication will change from
press
key to shift corresponding output pins and OUT_COM to short status.
Limit
EX-2005C
.
.
~
, then display "
" and all of the icons.
→ .
, the interface is working normally.
, the interface is not working normally.
, it means normal. If the display shows
28
, the
→ ,
ZSME300000116