JVC KD-DV5000 Service Manual page 7

3.1.3 Removing the front chassis assembly
(See Figs.3 and 4)
• Prior to performing the following procedures, remove the front
panel assembly and bottom cover.
(1) From the both sides of the main body, remove the two
screws B attaching the front chassis assembly. (See
Fig.3.)
(2) From the front side of the main body, remove the two
screws C attaching the front chassis assembly. (See
Fig.4.)
(3) From the both sides of the main body, release the two joints
d and two joints e. (See Fig.3.)
3.1.4 Removing the heat sink
(See Fig.5)
• Prior to performing the following procedure, remove the front
panel and front chassis assemblies as required.
(1) From the left side of the main body, remove the two screws
D and three screws E attaching the heat sink.
3.1.5 Removing the rear bracket
(See Fig.6)
• Prior to performing the following procedures, remove the bot-
tom cover.
(1) From the back side of the main body, remove the three
screws F, five screws G, two screws H, screw J, screw K
and screw L attaching the rear bracket.
(2) Remove the rear bracket.
Note:
When attaching the screws K and L, attach the AV cable and
antenna cable holders with them.
Joint d
B
Joint d
Front chassis assembly
Fig.3
C
Fig.4
E
Fig.5
Rear bracket
G
F
G F
Fig.6
Joint e
B
Joint e
Front chassis assembly
D
Heat sink
H J
F
K
L
Antenna
cable
AV cable holder
holder
(No.49879)1-7