JVC KD-DV5000 Service Manual page 16

3.2.8 Removing the rod (L)(R)/roller assembly
(See Fig.15 ~ 17)
• Prior to performing the following procedure, remove the top
cover, the mechanism section, the front unit and the loading
arm S.A.
(1) Release the rod (L) and (R) from the joints at the bottom of
the loading arm S.A.
(2) Remove the roller assembly from the loading A.ass'y.
(3) Remove the two collars and washer from the roller assem-
bly.
Caution:
After attaching the loading A.ass'y to the roller assembly, at-
tach the rod (L) and (R). Attach the rods to the right and left col-
lars of the roller as shown in Fig.16-1 and Fig.16-2.
When reattaching the rod (L) and (R) to the loading A.ass'y,
engage each joint as shown in Fig.15. As joint n of the rod (L),
let the rod through n before reattaching it.
1-16 (No.49879)
Fig.16-1
Collar
Rod(R)
Joint n
Joint n
Rod(R)
Loading A. ass'y
Joint n
Fig.15
Roller ass'y
Collar
Rod(L)
Fig.17
Fig.16-2
Collar
Rod(L)
Joint n
Joint n
Rod(L)
Joint n
Collar
Washer
Rod(R)
Loading A. ass'y