JVC KD-DV5000 Service Manual page 13

3.2.4 Removing the clamper unit
(See Fig.5 ~ 9)
• Prior to performing the following procedure, remove the top
cover and the mechanism section.
(1) Remove the clamper spring on the bottom of the mecha-
nism section.
(2) Release part d of the clamper spring from the bending part
of the chassis base assembly.
(3) Move the clamper unit in the direction of the arrow and turn.
Release the two joints e and f, then remove the clamper
unit upward.
3.2.5 Reattaching the clamper unit
(See Fig.5 ~ 9)
(1) Attach the clamper spring to the clamper unit.
(2) Move the clamper unit to set the side joints e and f to each
boss of the chassis base. Make sure that part g is inserted
to the notch of the chassis base.
(3) Move the clamper spring d to the outside of the bending
part of the chassis base.
Caution:
When reattaching, temporarily hook the end of the clamper
spring as shown in the figure to make the work easy.
Clamper spring
f
Clamper2 spring
Clamper2 spring
Chassis base
Clamper unit
g
e
Fig.5
Fig.6
Clamper spring
Chassis base
d
Fig.7
Clamper unit
Fig.8
Clamper unit
Fig.9
Clamper spring
g
Notch
(No.49879)1-13