JVC KD-DV5000 Service Manual page 18

3.2.10 Removing the spindle motor
(See Fig.21)
• Prior to performing the following procedure, remove the front
end board.
(1) Remove the two screws H attaching the spindle motor on
the bottom of the body.
Caution:
Perform adjustment when reattaching the spindle motor.
3.2.11 Removing the FL motor S.A.
(See Fig.22, 23)
• Prior to performing the following procedure, remove the front
end board.
(1) Remove the feed TRI.spring on the bottom of the body.
(2) Remove the two screws I attaching the FL motor SA.
(3) Remove the slit washer from the motor H.ass'y and pull out
the worm wheel.
(4) Remove the two screws J attaching the FL motor.
F.T.Spring
1-18 (No.49879)
I
FL Motor SA
Fig.22
Spindl motor
H
Fig.21
Slit washer
Worm wheel
J
Motor H.ass'y
Fig.23
FL Motor