Table of Contents
Advertisement
16. Secure and conceal the cables using UV resistant tie wraps. Tie wraps should also
be used to secure the cables along the Gooseneck.
17. If desired, attach the sun shields to the top/bottom using the captive screws. If
attaching the sun shields to the bottom of the unit, first remove the knock out discs
in the center to fit around the Yoke. Tighten the captive screws to between 39.9 and
53.1 inch pounds (lbf-in).
Once physical installation is completed the circuit powering the AP 7181 can be energized.
Verify that the green power LED is lit and the unit is powered on.
Hardware Installation
41
Advertisement
Table of Contents
