Table of Contents
Advertisement
10
AP 7181 Access Point: Installation Guide
2.10.1
Pole Mounted Installations
The optional Wall Gooseneck can also be used with the Pole Adapter for pole
mounting.
The Wall Gooseneck dimensions are 10x12x6 inches and it weighs 4 pounds. The Pole
Adapter dimensions are 4x2.62x7 inches and it weighs 3 pounds.
The Gooseneck attaches to the Yoke, which can be attached to the top or the bottom of
the AP 7181. Secure the Gooseneck and adaptor to the pole using band clamps with the
threaded portion pointing either up or down.
If using a bottom mount, drill a 1/4 inch diameter hole at the lowest point on the bend
to allow water to drain from the Gooseneck.
2.11 Installing an AP 7181
The following guidelines and procedures should be observed when installing an AP
7181 device.
2.11.1
Required Tools
The following is a list of the minimal tool set required to install an AP 7181 device:
•
24 mm Socket and driver - for cable gland
•
22 mm Socket and driver - for GE1 and GE2 port caps
•
19 mm Socket and driver - for Console port cap
•
21 mm Socket and driver - for set screw
•
8 mm Socket and driver - for ground screw
•
6 mm Allen Wrench bit - for mounting bracket (Yoke)
•
T27 Torx bit - for the Sun Shields
Advertisement
Table of Contents
