Table of Contents
Advertisement
12
www.electrolux.com
Clock function
7.2 Count Up Timer
The Count Up Timer starts to count when
the appliance starts to heat.
To reset the Count Up Timer, touch
and
shows "00:00" and the Count Up Timer
starts to count up again.
7.3 Setting the DURATION
1. Activate the appliance and set an oven
function and temperature.
2. Touch
display shows
flashes in the display.
3. Use
DURATION.
4. Touch
5. Use
DURATION.
6. When the set time ends, an acoustic
signal sounds for two minutes.
and time setting flash in the display.
The appliance deactivates.
7. Touch a sensor field to stop the
acoustic signal.
8. Deactivate the appliance.
END
The Count Up Timer is not
activated if Duration and End
are set.
at the same time until the display
again and again until the
.
or
to set the minutes for
to confirm.
or
to set the hours for
If you touch
while you
set the DURATION, the
appliance switches to the
setting of the END
function.
Application
To set when the appliance deactivates. You can use
Duration and End at the same time (Time delay) if you
want the appliance to activate and deactivate automat-
ically later.
7.4 Setting the END
1. Activate the appliance and set an oven
function and temperature.
2. Touch
display shows
flashes in the display.
3. Use
to confirm. First you set the minutes
and then the hours.
When the set time ends, an acoustic
signal sounds for two minutes.
and the time setting flash in the display.
The appliance deactivates.
4. Touch a sensor field to stop the
acoustic signal.
5. Deactivate the appliance.
7.5 Setting the MINUTE MINDER
Use the MINUTE MINDER to set a
countdown (maximum 2 h 30 min). This
function has no effect on the operation of
the oven. You can set the MINUTE
MINDER at any time and also when the
appliance is off.
1. Touch
and "00" flash in the display.
2. Use
MINDER. First you set the seconds,
then the minutes and the hours.
3. Touch
to reset the set time.
4. Touch
starts automatically after five seconds.
When the set time ends, an acoustic
signal sounds for two minutes and 00:00
and
5. Touch a sensor field to stop the
acoustic signal.
again and again until the
.
or
to set the END and
.
or
to set the MINUTE
and
at the same time
or the MINUTE MINDER
flash in the display.
symbol
Advertisement
Table of Contents
