Table of Contents
Advertisement
10
www.electrolux.com
Clock function
Press
switch between the clock
functions.
To confirm the settings of the
clock functions, press
wait 5 seconds for an
automatic confirmation.
6.2 Setting the DURATION or
END
1. Press
display shows
or
2. Press
and press
For Duration
and then the hours, for End
set the hours and then the minutes.
An acoustic signal sounds for 2 minutes
after the time ends.
time setting flash in the display. The oven
stops.
3. Turn the knob for the oven functions
to the off position.
4. Press any button to stop the acoustic
signal.
If you press
the hours for DURATION
the appliance goes to setting
of the END
6.3 Setting the MINUTE MINDER
1. Press
END
again and again to
again and again until the
or
.
flashes in the display.
or
to the set the values
to confirm.
first you set the minutes
or
when you set
function.
.
Application
To set when the appliance must deactivate. Use only
when an oven function is set. You can use Duration
and End at the same time (time delay), if the appliance
is to be activate and deactivate automatically later.
and "00" flash in the display.
2. Press
or
The appliance now calculates the time in
hours and minutes.
3. The MINUTE MINDER starts
4. When the set time ends, an acoustic
first you
symbol and
6.4 Count Up Timer
Use the Count Up Timer to monitor how
long the oven operates. It is on
immediately when the oven starts to heat.
To reset the Count Up Timer, press and
,
hold
up again.
or
to set the MINUTE
MINDER.
First you set the seconds, then the
minutes and then the hours.
At first, the time is calculated in
minutes and seconds. When the time
you set is longer than 60 minutes, the
symbol
comes on in the display.
automatically after five seconds.
After 90% of the set time, an acoustic
signal sounds.
signal sounds for two minutes.
"00:00" and
flash in the display.
Press any button to stop the acoustic
signal.
If you set the MINUTE
MINDER when the
DURATION
function operates, the symbol
comes on in the display.
and
. The timer starts to count
The Count Up Timer cannot
be used with the functions:
Duration
, End
temperature sensor.
or END
, core
Advertisement
Table of Contents
