Table of Contents
Advertisement
26
www.electrolux.com
3. Close the door until it is at an angle of
approximately 45°.
4. Hold the door with one hand on each
side and pull it away from the
appliance at an upwards angle.
5. Put the door with the outer side down
on a soft cloth on a stable surface.
This is to prevent scratches.
6. Hold the door trim (B) on the top edge
of the door at the two sides and push
inwards to release the clip seal.
B
7. Pull the door trim to the front to
remove it.
8. Hold the door glass panels on their
top edge one by one and pull them up
out of the guide.
A
45°
2
CAUTION!
Rough handling of the glass,
especially around the edges
of the front panel, can cause
the glass to break.
A
9. Clean the glass panel with water and
When the cleaning is completed, install the
glass panels and the door. Do the above
steps in the opposite sequence. Install the
smaller panel first, then the larger.
11.6 Replacing the lamp
Put a cloth on the bottom of the interior of
the appliance. It prevents damage to the
lamp glass cover and the cavity.
1. Deactivate the appliance.
2. Remove the fuses from the fuse box
The back lamp
1. Turn the lamp glass cover
2. Clean the glass cover.
3. Replace the oven lamp with a suitable
1
4. Install the glass cover.
The side lamp
1. Remove the left shelf support to get
2. Use a narrow, blunt object (e.g. a
soap. Dry the glass panel carefully.
WARNING!
Danger of electrocution!
Disconnect the fuse before
you replace the lamp. The
lamp and the lamp glass
cover can be hot.
or deactivate the circuit breaker.
The lamp glass cover is at the
back of the cavity.
counterclockwise to remove it.
300 °C heat-resistant oven lamp.
Use the same oven lamp type.
access to the lamp.
teaspoon) to remove the glass cover.
Advertisement
Table of Contents
