WEA453e Installation Manual
3.5
Connecting an Interface Cable
3.5.1
Connecting a PoE Cable
1) Prepare the following components:
Item
Installation
Section
Cable
Connectors
Required Tools
System Side
1
2
3
4
5
6
7
8
Shell
Samsung Electronics America
Table 22. Components and Tools for Connecting a PoE Cable
PoE Switch-Outdoor AP PoE Port
Ethernet Cable Assembly (S-FTP Cat.6, 4 Pair, ø8.1~ ø8.5)
PoE Switch
Check the specifications of the connector for the PoE switch
and have the connector ready.
Outdoor AP
RJ45
LAN Tool, LAN Tester, Nipper, Scissors, Wire Stripper, and Cable Cutter
Table 23. PoE Cable Pin Map
Color Map
White/Orange
Orange
White/Green
Blue
White/Blue
Green
White/Brown
Brown
Shield
The connector pin map provided above is for one linked to the system. Confirm
the pin link point for the connector that is linked to the cable before assembly.
Complete the following finishing touch to keep the ports for the system input/output
(power or external interface) and cable connection free of any foreign substances, air, or
moisture.
- Unused port or connection:
Use a waterproof cap, rubber packing, or other finishing materials.
- Port or connection with a cable installed:
After installing the cable, use a pressed sponge, rubber packing, or silicon to
remove any gaps in the port or the connection.
Description
Description
Gigabit Ethernet Tx/Rx0+
Gigabit Ethernet Tx/Rx0-+
Gigabit Ethernet Tx/Rx1+
Gigabit Ethernet Tx/Rx2+
Gigabit Ethernet Tx/Rx2-+
Gigabit Ethernet Tx/Rx1-+
Gigabit Ethernet Tx/Rx3+
Gigabit Ethernet Tx/Rx3-+
Shield
Version 1.0
Page 67 of 117