Suzuki Liana RH418 Supplementary Service Manual page 313

36) Remove 5 gaskets (1).
NOTE
Never reuse removed gaskets.
37) Remove planetary carrier (2), planetary ring gear (3)
and sun gear assembly (1) with the following sun
gear thrust roller bearing (4) installed.
Sun gear thrust roller bearing dimension
Outside diameter: 32.5 mm (1.28 in.)
Inside diameter: 18.8 mm (0.74 in.)
Thickness: 2.7 mm (0.11 in)
38) Pull out sun gear assembly.
39) Inspect 1st and reverse brake piston stroke.
a) Set special tools (dial gauge and magnetic
stand).
Special tool
(A): 09900–20607
(B): 09900-20701
b) Measure piston stroke while applying and
releasing compressed air (400 – 800 kPa, 4 – 8
kg/cm
1st and reverse brake piston stroke
Standard: 1.73 – 2.57 mm (0.068 – 0.101 in.)
NOTE
I2RH01510118-01
If piston stroke exceeds the specification,
inspect or replace plates.
I2RH01510119-01
40) Remove snap ring (1) using flat end rod or the like.
41) Remove retaining plates "R", friction plates "F" and
separator plates "S" in the following order.
R → F → S → F → S → F → S → F → S → F → R
Automatic Transmission/Transaxle:
2 , 57 – 113 psi) from oil hole (1).
5A-87
I3RH0B510031-01
I2RH01510121-01