Suzuki Liana RH418 Supplementary Service Manual page 310

5A-84 Automatic Transmission/Transaxle:
7) Pull out differential gear assembly.
8) Clean and wipe off gasket sealant on mating surface
between transaxle housing and transaxle case.
9) Remove three gaskets at transaxle case side.
NOTE
Never reuse removed gaskets.
10) Remove 6 bolts of oil pump body (1), then remove oil
pump body by hand.
NOTE
• Use care not to cause damage to shaft
bushing surface.
• If oil pump body can't be removed by hand,
remove it by using bearing puller as shown
in figure.
11) Remove oil reserve plate (1) by removing 2 bolts.
12) Remove oil strainer (2).
13) Remove manual detent spring (1) by removing 2
bolts.
14) Remove transaxle side cover (1) by removing bolts.
15) Remove transmission fluid temperature sensor (1)
from clamp.
16) Remove sensor harness from clamp (2).
17) Disconnect pressure control solenoid, shift solenoid-
A, shift solenoid-B and TCC solenoid connectors (3,
4, 5, 6).
I2RH01510102-01
18) Remove valve body assembly (1) by removing
seven bolts.
CAUTION
!
Be careful not to let manual valve fall off
when removing valve body assembly.
I2RH01510103-01
I2RH01510104-01
1
1
2
1
I2RH01510105-01
3
4
5
6
I2RH01510106-01
I2RH01510107-01