Suzuki Liana RH418 Supplementary Service Manual page 219

6) Apply grease to entire surface of cage. Use specified
grease in tube included in spare parts.
7) Insert cage into joint housing (2) and fit snap ring (1)
into groove of joint housing (2).
CAUTION
!
Position opening of snap ring "c" so that it
will not be lined up with a ball.
8) Apply grease to inside of joint housing (1), and then
fit boot (2) to joint housing. After fitting boot, insert
screwdriver into boot on joint housing side and allow
air to enter boot so that air pressure in boot becomes
the same as atmospheric pressure.
9) When fixing boot (1) to joint housing (2) with
differential side big band (3), adjust so that
measurements become as indicated in the following.
CAUTION
!
• Bend each boot band against forward
rotation (A).
• Do not squeeze or distort boot when
fastening it with bands. Distorted boot
caused by squeezing air may reduce its
durability.
Drive shaft boot fixing position (distance
between reference position and small boot band)
Left side drive shaft "d": 172.5 – 182.5 mm (6.79 –
7.18 in.)
Right side drive shaft "e": 193.0 – 203.0 mm (7.59
– 7.99 in.)
I2RH01310036-01
I2RH01310037-01
Drive Shaft / Axle: 3A-10
I3RH0B311004-01