Suzuki Liana RH418 Supplementary Service Manual page 207

Installation
1) If parts have been removed from fuel tank, install
them before installing fuel tank to vehicle.
2) Raise fuel tank (1) with jack and connect fuel pump
connector and ground wire harness and clamp wire
harness.
3) Install fuel tank to vehicle.
Tightening torque
Fuel tank bolt (a): 50 N·m (5.0 kgf-m, 36.5 lb-ft)
1
4) Connect fuel filler hose (1) and breather hose (2) to
filler neck as shown in the figure and clamp them
securely.
Tightening torque
Fuel filler hose clamp (a): 1.5 N·m (0.15 kgf-m,
1.0 lb-ft)
(a)
(a)
I2RH0B170023-01
3
2
1
I2RH0B170024-01
5) Connect fuel feed pipe (1), fuel return pipe (3) and
purge pipe (2) to each pipe as shown in the figure
and clamp them securely.
CAUTION
!
• When connecting joint, clean outside
surfaces of pipe where joint is to be
inserted, push joint into pipe till joint lock
clicks and check to ensure that pipes are
connected securely, or fuel leak may
occur.
• Never let the fuel hoses touch the ABS
sensor harness (if equipped).
1
2
6) Install EVAP canister with its bracket (1) to vehicle.
1
7) Remove muffler referring to "Exhaust Pipe Removal
and Installation in Section 1K in related manual".
8) Connect negative cable at battery. With engine OFF,
turn ignition switch to ON position and check for fuel
leaks.
Fuel System: 1G-7
3
I3RH0A170005-01
I2RH01170009-01