Suzuki Liana RH418 Supplementary Service Manual page 312

5A-86 Automatic Transmission/Transaxle:
27) Apply valve lifter as illustrated and push in brake
inner cover.
Special tool
(A): 09916-14510
(B): 09916-48210
28) Remove snap ring by using snap ring pliers (special
tool).
Special tool
(C): 09900-06108
29) Remove tools and take out 2nd and 4th brake piston
assembly (2).
NOTE
If 2nd and 4th brake piston assembly doesn't
come out, apply compressed air through oil
hole in figure of step 23)-b).
30) Remove spring (3).
1. Snap ring
31) Disassemble 2nd and 4th brake piston assembly.
a) Remove brake inner cover (1) and O-rings (2).
NOTE
Never reuse removed O-ring.
b) Remove E-ring (1), brake piston (2), spring (3)
and rod washer (4).
I2RH01510113-01
32) Loosen six bolts of transaxle rear cover (1).
33) Lightly and uniformly tap two rib sections of transaxle
rear cover (1), using plastic hammer.
34) Remove ten bolts and engine mounting LH bracket.
35) Pull out transaxle rear cover (1) with forward clutch
subassembly installed.
I2RH01510114-01
I2RH01510115-01
I2RH01510116-01
5. Piston rod
I2RH01510117-01