Suzuki Liana RH418 Supplementary Service Manual page 220

3A-11 Drive Shaft / Axle:
For center shaft
Install center shaft by reversing the removal procedure
and noting the following points.
For M/T model
• When installing circlip (1), make sure that if fits in
circlip groove in center bearing support (2) securely
as shown.
• Press-fit center shaft (1) from LH side, and then install
new O-ring (2) to center shaft.
"A": Grease 99000–25010
Amount
"A": 0.1 g (0.004 oz)
For A/T model
• When installing circlip (1), make sure that if fits in
circlip groove in center bearing support (2) securely
as shown.
1
I3RH0A311008-01
I3RH0B311005-01
2
I3RH0B311006-01
• Install oil seals (1, 2) to center bearing support (4) in
proper direction and specified position as shown using
special tool.
Special tool
(A): 09925–15410
Distance
"a": 0 – 1 mm (0 – 0.04 in.)
"b": 4 – 5 mm (0.16 – 0.19 in.)
• Fill the space between oil seals and center shaft
support bearing (3) with grease.
"A": Grease 99000–25010
Amount
"A": 2 – 3 g (0.07 – 0.10 oz)
1. LH oil seal
2. RH oil seal
• Press-fit center shaft (1) from LH side.
I3RH0B311007-01
1
I3RH0B311008-01