Suzuki Liana RH418 Supplementary Service Manual page 158

1D-32 Engine Mechanical:
4) Apply engine oil to sliding surface of each camshaft
and camshaft journal then install them as shown in
figure.
1
3
"a": Approx. 30°
5) Install camshaft housing pins (1) as shown in the
figure.
6) Check position of camshaft housings.
Embossed marks are provided on each camshaft
housing, indicating position and direction for
installation. Install housings as indicated by these
marks.
A: I: Intake side or E: Exhaust side
B: Position from timing chain side
2
"a"
4
5
I3RH0B140040-01
I2RH0B140077-01
I2RH0B140078-01
C: Pointing to timing chain side
7) After applying engine oil to housing bolts, tighten
them temporarily first. Then tighten them by the
following numerical order in the figure. Tighten a little
at a time and evenly among bolts and repeat
tightening sequence two or three times before they
are tightened to specified torque.
Tightening torque
Camshaft housing bolt (a): Tighten 11 N⋅m (1.1
kgf-m, 8.0 lb-ft) by the specified procedure
"10" "9" "2" "1",(a) "6" "5"
"20"
"17"
"19"
"18"
"21"
"12" "11" "4" "3"
8) With hexagonal section (1) of intake camshaft (2)
held stationary with spanner or the like, tighten bolt
of intake cam timing sprocket assembly (3) to
specification.
Tightening torque
Intake cam timing sprocket bolt (a): 60 N·m (6.0
kgf-m, 43.5 lb-ft)
3
(a)
9) Install timing chain with crankshaft sprocket referring
to "Timing Chain and Chain Tensioner Removal and
Installation".
10) Install timing chain cover referring to "Timing Chain
Cover Removal and Installation".
11) Check valve lashes referring to "Valve Lash
(Clearance) Inspection".
12) Perform Steps 11) to 16) of "Installation" of "Timing
Chain Cover Removal and Installation".
"14" "13"
"8" "7" "16" "15"
I3RH0B140041-01
1
2
I3RH0B140042-01