User Interface For Syslog - Cisco 3032 Software Configuration Manual

Configuring Multi-VRF CE
Beginning in privileged EXEC mode, follow these steps to configure VRF-aware services for uRPF. For
complete syntax and usage information for the commands, refer to the switch command reference for
this release and the Cisco IOS Switching Services Command Reference, Release 12.2.
Command
Step 1 configure terminal
Step 2 interface interface-id
Step 3
no switchport
Step 4 ip vrf forwarding vrf-name
Step 5
ip address ip-address
Step 6 ip verify unicast reverse-path
Step 7 end

User Interface for Syslog

Beginning in privileged EXEC mode, follow these steps to configure VRF-aware services for syslog. For
complete syntax and usage information for the commands, refer to the switch command reference for
this release and the Cisco IOS Switching Services Command Reference, Release 12.2.
Command
Step 1
configure terminal
Step 2
logging on
Step 3 logging host ip-address vrf vrf-name
Step 4 logging buffered logging buffered size
debugging
Step 5 logging trap debugging
Step 6 logging facility facility
Step 7
end
User Interface for Traceroute
Beginning in privileged EXEC mode, follow these steps to configure VRF-aware services for traceroute.
For complete syntax and usage information for the commands, refer to the switch command reference
for this release and the Cisco IOS Switching Services Command Reference, Release 12.2.
Command
traceroute vrf vrf-name ipaddress
Cisco Catalyst Blade Switch 3130 and 3032 for Dell Software Configuration Guide
38-84
Purpose
Enter global configuration mode.
Enter interface configuration mode, and specify the Layer 3 interface to
configure.
Remove the interface from Layer 2 configuration mode if it is a physical
interface.
Configure VRF on the interface.
Enter the IP address for the interface.
Enable uRPF on the interface.
Return to privileged EXEC mode.
Purpose
Enter global configuration mode.
Enable or temporarily disable logging of storage-router event message.
Specify the host address of the syslog server where logging messages
are to be sent.
Log messages to an internal buffer.
Limit the logging messages sent to the syslog server.
Send system logging messages to a logging facility.
Return to privileged EXEC mode.
Purpose
Specify the name of a VPN VRF in which to find the destination
address.
Chapter 38 Configuring IP Unicast Routing
OL-12247-04