Enabling A Partial Configuration - Cisco Catalyst 3750 Software Configuration Manual

Chapter 4 Configuring IE2100 CNS Agents
To disable the CNS configuration agent, use the no cns config initial {ip-address | hostname} global
configuration command.
This example shows how to configure an initial configuration on a remote switch. The switch host name
is the unique ID. The CNS Configuration Registrar IP address is 172.28.129.22.
Switch(config)# cns config connect-intf serial ping-interval 1 retries 1
Switch(config-cns-conn-if)# config-cli ip address negotiated
Switch(config-cns-conn-if)# config-cli encapsulation ppp
Switch(config-cns-conn-if)# config-cli ip directed-broadcast
Switch(config-cns-conn-if)# config-cli no keepalive
Switch(config-cns-conn-if)# config-cli no shutdown
Switch(config-cns-conn-if)# exit
Switch(config)# hostname RemoteSwitch
RemoteSwitch(config)# ip route 10.1.1.1 255.255.255.255 11.11.11.1
RemoteSwitch(config)# cns id Ethernet 0 ipaddress
RemoteSwitch(config)# cns config initial 10.1.1.1 no-persist

Enabling a Partial Configuration

Beginning in privileged EXEC mode, follow these steps to enable the CNS configuration agent and to
initiate a partial configuration on the switch:
Command
Step 1
configure terminal
Step 2
cns config partial {ip-address | hostname}
[port-number] [source ip-address]
Step 3
end
Step 4
show cns config stats
or
show cns config outstanding
Step 5
show running-config
Step 6 copy running-config startup-config
To disable the CNS configuration agent, use the no cns config partial {ip-address | hostname} global
configuration command. To cancel a partial configuration, use the cns config cancel privileged EXEC
command.
78-15870-01
Purpose
Enter global configuration mode.
Enable the configuration agent, and initiate a partial
configuration.
• For {ip-address | hostname}, enter the IP address or
the host name of the configuration server.
• (Optional) For port-number, enter the port number
of the configuration server. The default port number
is 80.
• (Optional) Enter source ip-address to use for the
source IP address.
Note Though visible in the command-line help string,
the encrypt keyword is not supported.
Return to privileged EXEC mode.
Verify information about the configuration agent.
Verify your entries.
(Optional) Save your entries in the configuration file.
Catalyst 3750 Metro Switch Software Configuration Guide
Configuring CNS Embedded Agents
4-11