Cisco Catalyst 3750 Software Configuration Manual page 47

Chapter 1 Overview
Table 1-1 Default Settings After Initial Switch Configuration (continued)
Feature
Passwords
TACACS+
RADIUS
System name and prompt
NTP
DNS
802.1x
Port parameters
Operating mode
Port enable state
Interface speed and duplex mode
Auto MDIX
Flow control
VLANs
Default VLAN
VLAN trunking
Trunk encapsulation
VTP mode
VTP version
Voice VLAN
Tunneling
802.1Q tunneling
VLAN mapping
Layer 2 protocol tunneling
Spanning Tree Protocol
STP
MSTP
Optional spanning-tree features
IGMP snooping
IGMP snooping
IGMP filters
MVR
78-15870-01
Default Setting
None defined
Disabled
Disabled
Switch
Enabled
Enabled
Disabled
Layer 2 (switchport)
All ports are enabled.
Autonegotiate
Disabled
Off
VLAN 1
Dynamic auto (DTP)
Negotiate
Server
1
Disabled
Disabled
Disabled
Disabled
PVST+ enabled on VLAN 1
Disabled
Disabled
Enabled
None applied
Disabled
Catalyst 3750 Metro Switch Software Configuration Guide
Default Settings After Initial Switch Configuration
More information in...
Chapter 5, "Administering the Switch"
Chapter 8, "Configuring 802.1x
Port-Based Authentication"
Chapter 9, "Configuring Interface
Characteristics"
Chapter 10, "Configuring VLANs"
Chapter 11, "Configuring VTP"
Chapter 12, "Configuring Voice VLAN"
Chapter 13, "Configuring IEEE 802.1Q
and Layer 2 Protocol Tunneling"
Chapter 14, "Configuring STP"
Chapter 15, "Configuring MSTP"
Chapter 16, "Configuring Optional
Spanning-Tree Features"
Chapter 17, "Configuring IGMP Snooping
and MVR"
1-9