Downloading A Configuration File By Using Ftp - Cisco Catalyst 3750 Software Configuration Manual

Appendix B Working with the Cisco IOS File System, Configuration Files, and Software Images
•
For more information, refer to the documentation for your FTP server.

Downloading a Configuration File By Using FTP

Beginning in privileged EXEC mode, follow these steps to download a configuration file by using FTP:
Command
Step 1
Step 2
Step 3
configure terminal
Step 4
ip ftp username username
Step 5 ip ftp password password
Step 6
end
Step 7
copy
ftp:[[[//[username[:password]@]location]/directory]
/filename] system:running-config
or
copy
ftp:[[[//[username[:password]@]location]/directory]
/filename] nvram:startup-config
This example shows how to copy a configuration file named host1-confg from the netadmin1 directory
on the remote server with an IP address of 172.16.101.101 and to load and run those commands on the
switch:
Switch# copy ftp://netadmin1:mypass@172.16.101.101/host1-confg system:running-config
Configure using host1-confg from 172.16.101.101? [confirm]
Connected to 172.16.101.101
Loading 1112 byte file host1-confg:![OK]
Switch#
%SYS-5-CONFIG: Configured from host1-config by ftp from 172.16.101.101
78-15870-01
NVRAM. If you are accessing the switch through a Telnet session and you have a valid username,
this username is used, and you do not need to set the FTP username. Include the username in the
copy command if you want to specify a username for only that copy operation.
When you upload a configuration file to the FTP server, it must be properly configured to accept the
write request from the user on the switch.
Purpose
Verify that the FTP server is properly configured by referring
to the "Preparing to Download or Upload a Configuration
File By Using FTP" section on page
Log into the switch through the console port or a Telnet
session.
Enter global configuration mode on the switch.
This step is required only if you override the default remote
username or password (see Steps 4, 5, and 6).
(Optional) Change the default remote username.
(Optional) Change the default password.
Return to privileged EXEC mode.
Using FTP, copy the configuration file from a network server
to the running configuration or to the startup configuration
file.
Catalyst 3750 Metro Switch Software Configuration Guide
Working with Configuration Files
B-12.
B-13